Agreed that how the music was converted and stored would have a big effect on how it will sound. I am in no way an audiophile as well, but can...
That turned out great! Congrats on the build. Do you hear a difference between Pandora and you CDs? For background listening I prefer Pandora...
Looking very nice. Have you powered them up yet, even for a quick listen?
There should be no issues mounting the boards even behind the CD, that's where I have mine mounted using 1/2" standoffs. The cutout for the CD is...
subscribed. Are you going to reinforce the junctions by adding a backing or doubling the entire baffle? Or are you going to leave it as is?
I have the 893 LCR and Volt 6 surround and front heights, subs are 2x Dayton 15" HO's below left and right speakers. I love the system a lot,...
Haha.That's right. It has been a while I have forgotten you bought some boards from me.
Since you are putting all LCR behind the screen I would suggest making them all the same. The bigger waveguides on the HTM10 or HTM12 may be...
BTW if you want crossover PCBs hit me up. I have some more left.
check out this thread: http://www.avsforum.com/forum/155-diy-speakers-subs/2503962-oak-veneered-diysg-893-build-3.html Interestingly he has it...
Somebody at AVS just posted about building ported versions of the 893. Apparently there was a plot of simulations Ryan made for the 893 ported vs...
Sorry but I have no idea what the final volume needs to be. I was going to wait until @LuisV builds his towers and just copy that. :) Not sure if...
When I build 893, I'd like them to have more low freq extension which may allow me to run it without subs (2 channel system). That may require...
I really like what you did with the corners. And yes I agree the grill looks great!
Very nice setup. How much improvement did you get from the acoustic panels and bass traps? Also how does the 893 play along with the UM18 (I...
You're welcome. So then I assume the pins marked as RED is connected to the top plane and the BLACK on the bottom plane?
The picture you posted does not look complete, is that correct? It looks like you overdid the thermals. The defaults you had would probably have...
Those numbers would be the minimum, and that is if the parts are actually 0.525mm max. I have one of the resistors and measured it to be 0.72mm....
Trace length should have no impact on temp rise. Are you using 1oz copper? Yeah, 0.762mm would be really small for the component leads to go...
External traces should have been fine. Are you using a SW for calculating trace widths? Can't tell for sure whether the pads are small, what is...
Separate names with a comma.
