It should be alright but I would recommend some thick damping material be placed across the box somewhere in the midsection to help reduce...
I've added mounting depth for the all the volt drivers to post #3. The volt-10 is 6" deep with the dna-150 attached so you will need at least...
Yep, that's correct.
Unfortunately the crossover is not likely to work as well with the Beta-12CX, you could try but the delays from the physical offset, frequency...
I am not sure if it comes cut or not. Besides the waveguide and CD do not take up very much internal volume, you would be looking at a change of...
I tried not getting into full baffle step, it's really closer to 4dB above 150hz but the close coupling of the woofers to the floor slowly...
Enclosure sizing is on post #2. Ideal sealed volume is around 1 cuft, beyond that you don't really gain much in terms of flatness or extension.
This would work. You don't port an IB back into the room like a ported enclosure if that is what you are asking, but it is ok if it is open to...
If the enclosure is built from 1/2" material you could get it down to 12"H x 8"W x 5.75" deep external, using included 3/4" baffle. They will...
This design works well at the current crossover point, both drivers are not pushed beyond what I consider safe or undesirable. Yes the BA750 with...
You might find the flat pack to be optimal in you situation. The measurement I took was outdoors up on a high stand (4pi), this provides useful...
Sorry file is quite large >150MB, won't go over email so well. If I get a chance I'll upload it to a file sharing site.
If you ordered the kit with the stock baffle you can just build the box 6.5" deep which will maintain the volume of the angled enclosure, but it...
This design was done for NWCgrad over on AVS forum. He inquired about using the beefier PSD2013-8 compression driver on the back of the...
No problem Rajdeep, it was nice to have someone stop by for a listen. Ryan, just let me know if you will be visiting the Chicago area at any...
I would recommend the volts for this, the coaxial design will give you even coverage no matter which direction you are from the speaker. The...
No I suppose not. It will work sealed if you were to use a 120hz crossover, in that case you could get away with a 0.1-0.2cuft enclosure. The...
Hi Bryan, The woofer will work sealed between 2-4cuft (F3 right about 80hz), it could be as simple as cutting the bottom portion with the port...
Those are internal enclosure volumes.
Really looking good. I don't think that gap is too bad, I had a similar sized gap around the waveguide on my enclosures for the MTG-08 design and...
Separate names with a comma.