Separate names with a comma.
Well a 50hz tune in a 3cuft cabinet with a single 4" port means it only needs to be about 1.5" long. Given those choices I would go with one of...
The crossover is well below the treble range and stuffing/damping inside the cabinet only affects the woofer. So I suspect that might just be...
The smaller cabinet won't change much if crossing at 80hz, not until you go below about 2cuft will it start to make a difference around 80hz. If...
I've tested these on my new turntable and made some adjustments to the crossover design which I have posted above. The new full detailed...
This is another idea that I have been kicking around for a couple years but finally purchased parts for and started messing with over the summer....
I don't have an assembled crossover to use for photos example but here is the example on a bare board with those two parts. Obviously you would...
Crossover mod to fix the HF small dip on the HTM-12 v2. In my opinion the dip is so small and narrow that you aren't likely to notice a sound...
Got an extra shipment of parts in and am now starting to assemble a few of these. Here is a quick photo of the assembled crossover: [ATTACH]
No the crossover should not require adjustment if you have Audyssey XT32, that should help smooth out any ripples in low midrange and upper bass...
Less so but part of it may be minor differences in the response through the lower midrange.
I've sent you a PM.
Boards arrived earlier then I expected. I still need to grab some photos but I've got a few sets of parts here and could start taking orders for...
I posted the enclosure specs in the thread on AVS Forum: https://www.avsforum.com/threads/diysg-vortex-15-builds.3206159/page-18#post-61186901
I'd say It's closest in size and performance to the S2000 kit but obviously the use of the ribbon tweeter in this design is a major difference...
For lack of better words the 15" had a slightly bigger sound to it with more full bottom end. Otherwise pretty similar.
There are the disconnects I usually use: 0.205" 1/4" I have these crimpers which I find work nearly as well as my nicer ratcheting crimpers for...
44Hz. I updated that post. I original listed just those values needed to be entered into WinISD to auto calculate the remaining parameters but...
I do have the original Fusion-6 cabinet and drivers I could throw together but I'm unsure how many more good days to test I'll have this year if...
Here is a link to the full set of Nexus MT measurements, these are taken with the new crossover modification. I've got the full polar response...
Ok, I'll be sure to export those instead, I wasn't sure which set of files were best. Here is the full set of polar response measurements for the...