Separate names with a comma.
Albertli, sounds like you might need to work on the "CD Compensation" part of the crossover. Can you post the entire tweeter crossover diagram of...
mfaugn, The box type or tuning doesn't affect the crossover (unless you are doing BSC in the crossover, then baffle size and distances from...
Hey, SpeakerScott, any new progress on your Synergies? I'm hoping you're still going forward and have more to write about, to keep up the...
Hi Chris, For the 3.5mH go with 266-560 (sorry for the typo). 266-916 would work, too, but I don't see the need to spend twice as much for it....
I'd think any SEOS12 speaker would be a good match at center It would set most of the speaker's character.
Yes, run a 1ยจ drill down that opening, then file the transitions smooth. Bill
JFA , sorry I missed your post questions. The TD12S would give lowest bass in smallest box. I don't know much about the RAAL, so nothing to...
donivan, The impedance is 8 ohms or more over most of the audio band, but dips to 4.7 ohms in a range around 1kHz (an 8 ohm receiver should do...
Hi Max, That should work. Bill
Why would the Eos be better for surrounds? But, sure it could be done, but would likely need a different crossover if all is to be as good as it...
I sold my big (bigger than Louis expected!) SEOS15+TD15M speakers today, with a promise that I'd do a passive crossover design for them. I had...
Nah, just on a horn. Never tried a Paraline (haven't seen a use for it yet in my stuff).
That effect seems to favor using smaller dia midranges. Path differences remain smaller even with very offset ports. I haven't had difficulty...
Incoming: new Synergy spreadsheet, docs on the way ("soon") I was hoping to get the revised spreadsheet out, along with detailed and illustrated...
Do you mean the short dimension (0.75in) for the woofer ports? That should be 0.75inch, 0.985in would be much larger. The port does widen on...
Sergey, Nope, an inch is 25.4mm (or 2.54 cm)! 5.475 inches is equal to 139.1mm....
Hi Sergey, Probably the confusion is because the diagram I drew doesn't really look much like the actual wood cuts. In actuality the four...
Like Jack and I said, though, it does require some insight -- you can't just combine raspberries, curling irons, toenails and - oh, ah - maybe...
Hi Paul, Your question was kind of hard to answer without knowing where you're coming from. I tried to respond with the function of the odd...
For passive crossover design it's best to not think in terms of "classic" filters (butterworth, cheby etc) There are a world of betweener types...