Separate names with a comma.
Product Page: http://www.diysoundgroup.com/home-theater-speakers/elusive-1099.html CINEMA ELUSIVE 1099 I want to thank: Erich Fatshaft dtsdig...
Well this was frustrating. I jigsawed out the woofer hole and... [IMG] So I measured to see where I went wrong. Turns out I was right on the...
I personally use unibox and winisd, but hoping to upgrade to soundeasy soon. Been saving. The only way I know to calculate bracing is with some...
I'm not totally sure I'm understanding you, but here's my best shot. You design the cab volume based on the woofer you're using. For this woofer...
dts, because it's not a very tall box, I figures this might be stiffer and easier. I'm not sure it was, but it's what I did. As far as materials,...
Haha! I heard Calgary got cold ;) Yes, PI probably would know a few tricks. I'm through most of it now, but still need to safely flush trim...
Ok so I cut the woofer recess. Nothing special there. I put a tall scre in the woofer center. Flip my router edge guide upside down. Set the...
Ha ya, bad time to do the vid. They were in the middle of laying and they get real yappy. I think I'll do some more vids. They convey more...
A little video explain this process a bit. I'd love to hear how else this sort of thing can be handled with less expensive bits. Hope you like...
Thanks MTG, but I went ahead and made a new template. It's almost to tight now. [IMG] Before making the WG cut outs, I got the sides flush using...
I bought a shorter router bit. It'll a down cutting spiral hing bit. Often used to make the recesses for door hinges. I need to build some doors...
This is transtint black in pre-cat lacquer on maple. [IMG] Just enough to smoke it. Not as brown as the photo looks. More grey. This is a...
I've used dye as a stain and as a toner in my finish. In both cases I didn't find them remarkable. They have a different look than the usual...
Ok time to potentially ruin these speakers :o Made a SEOS 10 template by tracing the waveguide and using a spindle sander. I gotta quickly...
Finally put some time in on these. It should move a little quicker towards the end now. Needed to flatten the baffle so I rigged up a router...
Thanks Don. I'm still not sure about finish. I'm thinking a light coat of shellac to seal it up, followed by a black grain filler on the walnut...
I'm all ready to go on affixing the baffle, but I forgot I want to put neo magnets behind it. Nearly went ahead and totally forgot about it, but...
Hey sorry I never saw this post until now some how. I agree about 1500hz or even lower XO would probably be right. Can't the asd1001 get down...
Ya I'll hit the inside with my finish. And I think I should use epoxy as the adhesive. Expensive though, but better to pay for some epoxy now than...
I thought of that, but I'm going to be irresponsible anyways :P Today I trimmed down the baffles so final trimming wouldn't be bad. [IMG]...