Separate names with a comma.
@Matt Grant Does it matter if I use side panels measuring 18.5" wide by 44" tall instead of 17"w x 44"T? I am not sure how I cut them large like I...
Those 15's look so tiny! ;)
"M" for Magnificent, Matt included! :)
I am curious about the baffle being set back like that. While I like the look, does it have any negative effects on the frequency response?
I don't have JTR's, this is the only way I can attempt to make something comparable to them. I had looked at buying JTR's, just couldn't do it. I...
I just finished cutting my third sheet of MDF into small pieces for the pair of Vortex-15's I will be building soon. I was going to put three...
Terrible! Sorry about that. Keep those Elusive 1099's going, even if the price has to go up. I finally have my trio up and running, they are...
Gone! And it isn't looking good for the 1099's........ The woofer used is now in the clearance section, and that may also be the midrange listed...
You're NOT getting a like for that! :) I bought a table saw just to handle these new enclosures I plan on building. My old one could only do a...
How do they sound? Are they sitting on the floor? Have you run REW to get a frequency response from them? I still have to build mine, not sure if...
I already have 4 of these, two Vortex-15's, I think I'll let some other people have a shot at buying some this time around.
Matt, how much would a speaker available commercially cost that would be comparable to this? Always curious as to the cost benefit of DIY vs....
Did you reflow that first board? Lots of cold solder joints on it. The other one looks perfect.
Now you did it! Made nice cabinets and don't want to disconnect them to finish them......... I wanted to hear my GSG Devestators when I had them...
How's the progress? I don't know how I missed all those wood clamps. Reminds me of wood shop in high school. If you can get down inside the...
I like the miter cuts! I will build my cabinets from MDF and veneer them, if I don't like them then it will be BB, but I am sure the MDF will be fine.
I have a set of Vortex-15's to build and now I am looking at how to design the cabinets. I would prefer a slot port in the front, but those...
I am curious about this too. I was thinking of the Volt-8 or Volt-10 since the surrounds will be about 6 feet or less from the listening position....