Separate names with a comma.
I can answer a few of those questions. Yes there should be two of those 20uF capacitors, one goes with the woofer circuit and one on the cd....
Here is a slot port version, I changed the depth a little just because I like sub boxes to be a little deeper then they are high. One that shows...
Well I ran into a slight snag with the single 4" port in that I could not get both the woofer and port to fit on the same face. So this revision...
Actually fitting the port tube in there may present an even greater challenge. Too bad that 4cuft ported flat pack won't fit a 15". The 15" RS HF...
Woofer: http://www.parts-express.com/pe/showdetl.cfm?partnumber=295-469 Plate amp:...
Are you looking to build a DIY sub or buy one? Budget? Size limits?
Yeah no need to go with the Sentinel's for surrounds unless you are the type of person that wants to make sure they get all identical speakers and...
The crossover would need to be redone for that one, sensitivity is a little lower and frequency response is different. Box size and tuning would...
Thanks, On that one I start about 120 feet back, I did not have an SPL meter out there but I estimate that at 1m it was hitting peaks of around...
I think they look great, good job!
I forgot to take some impedance measurements of the finished speakers with the WT3 but I have the simulated impedance which should be pretty much...
Whoops ;D Thanks Tux, looks like I was not paying attention while drawing that up Fixed.
Re: AE TD15M-4 + BMS 4550(16 ohm) / DNA-360 SEOS-12 build Here is a TD15M-8 design which I did with help from lennon_68 who provided me with an...
You may be able to find some on Ebay but they will usually be priced a bit higher then $9 a piece. No direct substitute for the Aura's I do have...
I have not had much experience with other pro mids unless you count the B&C 8PS21 or Celestion TF0818 as mids, and no other 6" pro mids just hi-fi...
Crossover design update, go to post #14 to see new schematics. The other design I did for Bass Addict, TD15M-4 (thanks to Mark Seaton for...
This is the design I had done for Bass Addict over on AVS. They use two AE TD6M-8 woofer and the BMS 4550 (16ohm) CD on the SEOS-12 These will...
Yep that would be the same as flipping the speaker upside down. The time/phase alignment made in the crossover it what determines the position of...
Yeah DNA-150 is one of my favorites, not many know what a gem that is and the value is just unbeatable. I was listening to this design outside...
No unfortunately it would require a different crossover.