Separate names with a comma.
I have a somewhat similar dip on my measurement even with the port sealed. The port resonance with the slot ports included is around 1700hz, it...
If you are crossing over to a sub model with a highpass filter. IIRC most avr's use a 2nd order highpass on the speakers and a 4th order lowpass...
1100-1200hz may be a little low for the DNA-205 when run at higher volume levels. I dug up two of my measurements for the 8PS21 and both show...
Probably close enough that you would not notice with the playback of regular material.
I am switching the current Dayton (JBL clone) waveguides and DNA-150's that are on it out for SEOS-12's and DNA-205's, woofers will stay the same....
6" foam roller. :)
Thanks, paint is Rustoleum oil based flat black. I like that it goes on smooth and is very durable when dry but it does stink and cleanup is a mess.
They seemed to be well packed when I got them from PE. Everything was double boxed and the P-cores were in their own box separate from the other...
The Cheap Thrill does sound like a good candidate for you, come within your budget, have the needed oomph to get the job done and are the current...
It's not too bad, you have them point the right way as to minimize coupling. If you are worried about it you could always flip it over so it is...
Can't view your picture, makes it a tad hard to answer :o
The port should be 1" high by 6" long, so cut the internal port panel 5.25" long (+ 0.75 for baffle = 6"). You may be able to use the bottom...
Yes 1050Hz, Not Linkwitz Riley (LR) filters, use Butterworth, BW 18dB/oct is what it will say in the minidsp drop down box for filter settings....
If you want here are active settings that mirror the passive version, Woofer: 3rd order BW @ 1050Hz 1800Hz, 4dB, Q=2 2800Hz, -10dB, Q=2 CD:...
Changing the compression driver would require a redesign of the crossover, you can't just swap them out. I also think you would be hard pressed...
Yeah that looks correct.
Yeah the HF is better in sealed enclosures as its native response will extend down further (lower F3 then the HO in the same enclosure). For a...
I think any of those coils would be fine, the differences in resistance (a few hundredths' of an ohm) are negligible for the intended application.
They should work fine for the HT listening with the solid state amp but I know tube amps can be picky about what the speaker impedance looks like....
Well lets just say you can't measure the difference besides maybe the tighter tolerances of the Mundorf. Whether or not you can hear the...